Stop Fighting Bathroom Mold With a Scrub Brush
Most people think of infrared heaters as just a way to stop shivering while you get dressed. But we looked at them differently. We wanted to build something that actually fights the humidity and stops mold from moving in. Here’s how it works. Instead of just heating up the air—which is what those old-school convection heaters do—we use short-wave infrared. Think of it like sunlight. It doesn’t wait for the air to get warm; it goes straight through the steam and hits your walls and ceiling. It creates a quick burst of heat right on the surface. Because the walls stay warm, the water can’t settle. No condensation, no standing water, and no place for mold spores to start a colony. It’s a simple fix for a gross problem. Now, bathrooms are tough on electronics. Steam gets everywhere. To keep these things from burning out, we seal the electrical parts with high-temp silicone. We also use tempered quartz glass, so when a cloud of cold steam hits a hot element, the glass doesn’t shatter. One heads-up, though: these units pack a punch. They pull a lot of power. Make sure your wiring and breakers can handle the wattage, or you’ll be flipping the switch in your breaker box every time you turn the heat on. But the real magic is in the wavelength. We’ve tuned these lamps to dry out surfaces way faster than a vent or a fan ever could. You aren’t just warming the room; you’re basically flash-drying your walls. The only downside? They’re bright. Like, really bright. Depending on the wattage, the glare can be a bit much for your eyes first thing in the morning. We suggest tucking them into the ceiling. That way, the heat beams straight down to dry your floors and walls without blinding you.