Stop Streaks Before They Become a Headache
You know that frustration—looking at a freshly coated glass panel and seeing streaks. It’s usually one thing: uneven heat. When your infrared lamp can’t lay down a steady, even thermal field, the coating cures in patches. And those patches show up as streaks. We built our glass insulation drying lamp to fix that. It gives you uniform curing, so the finish comes out clean—right off the line.
Power That Matches the Reality of the Line
Here’s the thing: heat has to fit the job. That’s why we set this up with a 400V input—standard in industrial lines. It gives you the voltage headroom to run high-wattage elements without the power dipping when you need it most. The 300mm tube length and 2500W rating aren’t random, either. They’re chosen to drop straight into typical coater zones, packing serious heat density into a compact footprint. It’s a direct-fit lamp. Wire it up, set the focus, and the heat lands exactly where you want it.
Built to Survive the Heat Cycle—Again and Again
Inside, it’s halogen technology in a quartz envelope. That means fast response and stable output, even when the system cycles on and off repeatedly. The coating isn’t just for looks. It helps control the spectral profile and prevents hot spots that cause uneven curing. Installation is straightforward, too. The R7s connector keeps it repeatable, and the Sk15 base option gives you compatibility across different fixtures. This lamp is made to take the thermal shock of start-stop operation without burning out early.
What It Feels Like on the Line
On the glass line, you don’t want guesswork. You want repeatable curing, shift after shift. This setup delivers uniform infrared heat across the target area, so the coating dries evenly and surface quality stays consistent. It starts fast. Holds temperature. And keeps giving you the same results. Just keep one thing in mind: that 2500W density means serious heat. Make sure your machine’s cooling and airflow are up to the task. Otherwise, heat building up in the area can shorten component life.
If Streaks Are Your Problem, This Is the Fix
When you see streaks after coating, the root is often the thermal field. Swap in a lamp built for uniformity, and you get a repeatable cure profile—and a lot fewer rejects.